Chevrolet Trax: Diagnostic information and procedures
Chevrolet Trax (2013-2022) Workshop Manual / HVAC & Restraints / Supplemental Inflatable Restraints / Diagnostic information and procedures
- DTC B0012 OR B0013: Driver steering wheel air bag deployment loop
- DTC B0014, B0021, B0031, OR B0038: Seat side air bag deployment loop
- DTC B0015, B001A, B001B, OR B0022: Seat belt retractor pretensioner deployment loop
- DTC B0016, B0018, B0023, OR B0025: Roof rail air bag deployment loop
- DTC B0017 OR B0024: Knee air bag deployment loop
- DTC B0019 OR B0020 (WITHOUT AY0 OR AYF): Passenger instrument panel air bag deployment loop
- DTC B0019 OR B0020 (WITH AY0 OR AYF): Passenger instrument panel air bag deployment loop
- DTC B0052: Deployment commanded
- DTC B0074: Passenger presence sensor
- DTC B0081 (Inflatable restraint sensing and diagnostic module): passenger presence module
- DTC B0081: Passenger presence module
- DTC B0083-B0088: Side/front impact sensor
- DTC B0091: Center front impact sensor
- DTC B1001: Option configuration
- DTC B1019: System configuration error
- Passenger presence system rezeroing
- Airbag indicator malfunction
- Sir disabling and enabling
READ NEXT:
DTC B0012 OR B0013: Driver steering wheel air bag deployment loop
DIAGNOSTIC CODE INDEX
DTC B0012 OR B0013: DRIVER STEERING WHEEL AIR BAG DEPLOYMENT LOOP
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnost
DTC B0014, B0021, B0031, OR B0038: Seat side air bag deployment loop
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
DTC B0015, B001A, B001B, OR B0022: Seat belt retractor pretensioner
deployment loop
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
SEE MORE:
DTC B3950
Ignition OFF, disconnect the X2 harness connector at the K9 Body Control
Module, ignition ON.
Verify a test lamp illuminates between the B+ circuit terminal 3 and
ground.
If the test lamp does not illuminate and the circuit fuse is good
Ignition OFF.
Test for less than 2 ohms in the B+
Heater and air conditioning control replacement
Fig. 6: Heater And Air Conditioning Control
Heater and Air Conditioning Control Replacement
HEATER AND AIR CONDITIONING REMOTE CONTROL REPLACEMENT
Fig. 7: Heater And Air Conditioning Remote Control
Heater and Air Conditioning Remote Control Replacement
AIR INLET VALVE ACTUATOR REPLACEMENT -
© 2019-2024 Copyright www.chevtrax.com
