Chevrolet Trax: Lighting - Repair instructions
Chevrolet Trax (2013-2022) Workshop Manual / Accessories & Equipment / Lighting / Lighting - Repair instructions
- Brake pedal position sensor calibration
- Headlamp switch replacement (encore)
- Center reading lamp replacement
- Windshield header courtesy lamp replacement
- Headlamp replacement
- Headlamp aiming
- Front fog lamp replacement (trax)
- Fog lamp aiming
READ NEXT:
Brake pedal position sensor calibration
NOTE:
Brake system does not use a brake switch, stoplight switch or brakelight
switch. System uses a Brake Pedal Position Sensor to control these functions.
Calibration Criteria
NOTE:
Do not apply the
Headlamp switch replacement (encore)
Fig. 5: Headlamp Switch
Headlamp Switch Replacement (Encore)
HEADLAMP SWITCH REPLACEMENT (TRAX)
Fig. 6: Headlamp Switch
Headlamp Switch Replacement (Trax)
HAZARD WARNING SWITCH REPLACEMENT (TR
Center reading lamp replacement
Fig. 10: Center Reading Lamp
Center Reading Lamp Replacement
CENTER READING LAMP BULB REPLACEMENT
Fig. 11: Center Reading Lamp Bulb
Center Reading Lamp Bulb Replacement
CENTER READING AND COUR
SEE MORE:
Auxiliary audio input malfunction
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provide an overview of each diagnostic
category.
Diagnostic Fault I
Power steering system bleeding
NOTE:
Use clean, new power steering fluid only. Refer to Adhesives, Fluids,
Lubricants, and Sealers.
Hoses touching the frame, body or engine may cause system noise.
Ensure the hoses do not touch any other part of the vehicle.
Loose connections may not leak, but could allow air into the steer
© 2019-2025 Copyright www.chevtrax.com
