Chevrolet Trax: Engine Oil Pressure Light
Caution
Lack of proper engine oil maintenance can damage the engine. Driving with the engine oil low can also damage the engine. The repairs would not be covered by the vehicle warranty.
Check the oil level as soon as possible. Add oil if required, but if the oil level is within the operating range and the oil pressure is still low, have the vehicle serviced.
Always follow the maintenance schedule for changing engine oil.
.gif)
This light should come on briefly
as
the engine is started. If it does not
come on, have the vehicle serviced
by your dealer.
If the light comes on and stays on, it means that oil is not flowing through the engine properly. The vehicle could be low on oil and might have some other system problem. See your dealer.
Low Fuel Warning Light
.gif)
This light comes on for a few
seconds when the ignition is turned
on as a check to indicate it is
working. If it does not come on,
have it fixed.
This light comes on when the vehicle is low on fuel.
The low fuel warning light comes on when there are approximately 6.0 L (1.7 gal) of fuel remaining in the tank.
To turn the light off, add fuel to the fuel tank. See Filling the Tank
Immobilizer Light
.gif)
The immobilizer light should come
on briefly as the engine is started.
If it does not come on, have the vehicle serviced by your dealer.
If the system is working normally, the indicator light turns off.
If the light stays on and the engine does not start, there could be a problem with the immobilizer system. See Immobilizer Operation
Reduced Engine Power Light
.gif)
The reduced engine power light
should come on briefly as the
engine is started. If it does not come
on, have the vehicle serviced by
your dealer.
This light, along with the malfunction indicator lamp, displays when a noticeable reduction in the vehicle's performance occurs.
The vehicle can be driven at a reduced speed when the reduced engine power light is on but acceleration and speed might be reduced. If this light stays on, see your dealer as soon as possible for diagnosis and repair.
READ NEXT:
High-Beam On Light
This light comes on when the
high-beam headlamps are in use.
See Headlamp High/Low-Beam
Changer
Daytime Running Lamps
(DRL) Indicator Light
If equipped, this light turns on
whenever the Daytime Runni
Information Displays
Driver Information Center (DIC)
If equipped, the DIC displays
information about your vehicle.
It also displays warning messages if
a system problem is detected. See
Vehicle Messages on page 5-25. All
Vehicle Messages
DIC messages display when the
status of the vehicle has changed
and action may be needed to
correct the condition. Multiple
messages appear one after another.
Press any of the DIC buttons on the
turn
SEE MORE:
Antilock brake system automated bleed
WARNING: Refer to Brake Fluid Irritant Warning .
CAUTION: Refer to Brake Fluid Effects on Paint and Electrical
Components Caution .
NOTE: Before performing the Antilock Brake System (ABS) Automated
Bleed
Procedure, first perform a pressure bleed of the base brake system. Refer to
Hydraulic Brake S
Turbocharger removal
Special Tool
EN-49942 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Fig. 261: Holding Wrench And Ratchet Wrench
Install the EN-49942 holding wrench (2) to the turbocharger coolant feed
pipe. Guide a ratchet wrench
(1) along with an extension through EN-49942 holding wr
