Chevrolet Trax: Repair instructions
Chevrolet Trax (2013-2022) Workshop Manual / Suspension & Steering / Rear Suspension / Repair instructions
- Rear wheel bearing and hub replacement (with disc brakes)
- Rear wheel bearing and hub replacement (with drum brakes)
- Rear axle replacement
- Wheel stud replacement
READ NEXT:
Rear wheel bearing and hub replacement (with disc brakes)
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
REPAIR INSTRUCTIONS
REAR WHEEL BEARING AND HUB REPLACEMENT (WITH DISC BRAKES)
Special Tools
CH 50559 Wheel Hub/Be
Rear wheel bearing and hub replacement (with drum brakes)
Fig. 9: Rear Wheel Bearing And Hub (With Drum Brakes)
Rear Wheel Bearing and Hub Replacement (With Drum Brakes)
STRUT AND SHOCK ABSORBER INSPECTION
NOTE: The shock absorber assembly DOES NOT have
Rear axle replacement
Special Tools
CH 51035 Rear Axle Supporter Adapter
DT 50187 Rear Axle Supporter
For equivalent regional tools, refer to Special Tools .
Removal Procedure
Raise and support the vehicle. Refer to
SEE MORE:
DTC B302A: Mobile telephone communications interface requested
immobilization
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
DTC Descriptor
DT
Rear output shaft seal replacement
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
Drain the transfer case fluid. Refer to Transfer Case Fluid Replacement.
Remove the rear propeller shaft. Refer to Two-Piece Propeller Shaft
Replacement .
Remove the rear output shaft housing. Refer
© 2019-2024 Copyright www.chevtrax.com
