Chevrolet Trax: Power Seats

Chevrolet Trax (2013-2022) Workshop Manual / Accessories & Equipment / Power Seats

SCHEMATIC WIRING DIAGRAMS

DRIVER SEAT WIRING SCHEMATICS (ENCORE)

Power Seat (Without AAG) and Lumbar

Fig. 1: Power Seat (Without AAG) and Lumbar

Module Power, Ground, Serial Data, and Memory Controls (AAG)

Fig. 2: Module Power, Ground, Serial Data, and Memory Controls (AAG)

Seat Adjuster Switch and Position Motors (AAG)

Fig. 3: Seat Adjuster Switch and Position Motors (AAG)

DRIVER SEAT WIRING SCHEMATICS (TRAX)

Power Seat and Lumbar

Fig. 4: Power Seat and Lumbar

PASSENGER SEAT WIRING SCHEMATICS (ENCORE)

Power Seat

Fig. 5: Power Seat

SEE MORE:

Rear compartment lamp malfunction

Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Review Strategy Based Diagnosis for an overview of the diagnostic approach. Diagnostic Procedure Instructions provides an overview of each diagnostic category Diagnostic Fault I

Battery disconnect warning

WARNING: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with

Chevrolet Trax: Power Seats

READ NEXT:

Power Seats - Diagnostic information and procedures

DTC B1735, B1740, B1745, B1750, B1755, B1760, B1815, OR B1820: Driver seat switch

DTC B1825, B2355, B2365, OR B2375: Driver seat front vertical position sensor

SEE MORE:

Rear compartment lamp malfunction

Battery disconnect warning