Chevrolet Trax: Heated Front Seats
Warning
If you cannot feel temperature change or pain to the skin, the seat heater may cause burns. To reduce the risk of burns, people with such a condition should use care when using the seat heater, especially for long periods of time. Do not place anything on the seat that insulates against heat, such as a blanket, cushion, cover, or similar item. This may cause the seat heater to overheat. An overheated seat heater may cause a burn or may damage the seat.
.gif)
If available, the controls are on the climate control panel. To operate, the engine must be running.
Press .gif)
or
.gif)
to turn the driver or
passenger heated seat on or off.
The indicator light on the control turns on when this feature is on.
The passenger seat may take longer to heat up.
Remote Start Heated Seats
If available, the heated seats can be turned on automatically during a remote start when it is cold outside.
The heated seats will be canceled when the ignition is turned on. Press the control to use the heated seats after the vehicle is started.
The heated seat indicator lights do not turn on during a remote start.
The temperature performance of an unoccupied seat may be reduced.
This is normal.
The heated seats will not turn on during a remote start unless the heated seat feature is enabled in the vehicle personalization menu.
See Remote Vehicle Start and Vehicle Personalization
READ NEXT:
Folding Seatback
The front passenger seatback may
fold flat.
Warning
If you fold the seatback forward to
carry longer objects, such as skis,
be sure any such cargo is not near an airbag. In a crash, an
inflating airba
Folding the Seatback
Either side of the seatback can be
folded down for more cargo space.
Fold a seatback only when the
vehicle is not moving.
Caution
Folding a rear seat with the safety
belts still fastened may cause
da
SEE MORE:
Master cylinder replacement
Removal Procedure
WARNING: Refer to Brake Fluid Irritant Warning .
CAUTION: Refer to Brake Fluid Effects on Paint and Electrical
Components Caution .
Place the ignition switch in the OFF position.
Remove the battery. Refer to Battery Replacement .
Disconnect the brake fluid level indicator swit
Body tail lamp filler panel replacement
Removal Procedure
WARNING: Refer to Approved Equipment for Collision Repair Warning .
WARNING: Refer to Glass and Sheet Metal Handling Warning
Disable the SIR System. Refer to SIR Disabling and Enabling .
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and
