Chevrolet Trax: Bolted Exterior Body Panels and Closures - Repair instructions
Chevrolet Trax (2013-2022) Workshop Manual / Accessories & Equipment / Bolted Exterior Body Panels and Closures / Bolted Exterior Body Panels and Closures - Repair instructions
- Front end upper tie bar replacement
- Rear side door replacement
- Front side door upper hinge and lower hinge replacement
- Headlamp mount panel bracket replacement
- Fuel tank filler door latch housing replacement (encore)
- Hood rear weatherstrip replacement (encore)
READ NEXT:
Front end upper tie bar replacement
Fig. 3: Front End Upper Tie Bar
Front End Upper Tie Bar Replacement
HOOD PRIMARY LATCH RELEASE CABLE REPLACEMENT (TRAX)
Fig. 4: Hood Primary Latch Release Cable
Hood Primary Latch Release Cabl
Rear side door replacement
Fig. 9: View Rear Side Door
Rear Side Door Replacement
FRONT FENDER REPLACEMENT
Fig. 10: Front Fender
Front Fender Replacement
LIFTGATE ADJUSTMENT (TRAX)
Fig. 11: Liftgate Adjustment Poi
Front side door upper hinge and lower hinge replacement
Fig. 15: View Of Front Side Door Hinge
Front Side Door Upper Hinge and Lower Hinge Replacement
HOOD HINGE REPLACEMENT
Fig. 16: Hood Hinge
Hood Hinge Replacement
LIFTGATE HINGE REPLACEMENT
SEE MORE:
DTC C0297
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
DTC Descriptor
DT
Turbocharger removal
Special Tool
EN-49942 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Fig. 261: Holding Wrench And Ratchet Wrench
Install the EN-49942 holding wrench (2) to the turbocharger coolant feed
pipe. Guide a ratchet wrench
(1) along with an extension through EN-49942 holding wr
© 2019-2024 Copyright www.chevtrax.com
