Chevrolet Trax: Symptoms - vehicle
Body Repair
Symptoms - Bolted Exterior Body Panels and Closures
Body Systems
- Symptoms - Fixed and Moveable Windows
- Symptoms - Horns
- Symptoms - Lighting
- Symptoms - Mirrors
- Symptoms - Vehicle Access
- Symptoms - Wiper/Washer Systems
Brakes
- Symptoms - Antilock Brake System
- Symptoms - Hydraulic Brakes
- Symptoms - Park Brake
Driveline/Axle
- Symptoms - Propeller Shaft
- Symptoms - Wheel Drive Shafts
Driver Information and Entertainment
- Symptoms - Cellular Communication
- Symptoms - Entertainment , Symptoms - Entertainment
- Symptoms - Displays and Gauges
- Symptoms - Secondary and Configurable Customer Controls
Engine
- Symptoms - Engine Electrical
- Symptoms - Cruise Control
- Symptoms - Engine Controls - 1.2L (L2Q LDC LWD) or 1.4L (L2I L2N LDD LUH
LUJ LUV) engine
- Symptoms - Engine Cooling
- Symptoms - Engine Mechanical - 1.2L (L2Q LDC LWD) or 1.4L (L2I L2N LDD
LUH LUJ LUV)
engine
- Symptoms - Engine Exhaust
General Information
Symptoms - Vibration Diagnosis and Correction
HVAC
- Symptoms - HVAC Systems - Automatic
- Symptoms - HVAC Systems - Manual
Power and Signal Distribution
- Symptoms - Data Communications
- Symptoms - Power Outlets
- Symptoms - Wiring Systems
Roof
Symptoms - Roof
Safety and Security
- Symptoms - Immobilizer
- Symptoms - Object Detection
- Symptoms - Remote Functions
- Symptoms - Seat Belts
- Symptoms - SIR
- Symptoms - Theft Deterrent
Seats
- Symptoms - Power Seats
- Symptoms - Seat Heating and Cooling
Steering
- Symptoms - Power Steering System
- Symptoms - Steering Wheel and Column
Suspension
- Symptoms - Suspension General Diagnosis
- Symptoms - Tire Pressure Monitoring
Transmission
- Symptoms - Automatic Transmission - 6T30/6T40/6T45/6T50 automatic
transmission
- Symptoms - Clutch
- Symptoms - Manual Transmission - D16/D20 manual transmission
- Symptoms - Manual Transmission - M20/M32 manual transmission
- Symptoms - Automatic Transmission Shift Lock Control
- Symptoms - Transfer Case
ENGINE DOES NOT CRANK
Refer to the appropriate diagnostic procedure below for the symptom observed.
- Starter Solenoid Does Not Click
- Starter Solenoid Clicks, Engine Does Not Crank
- Engine Cranks Slowly
ENGINE CRANKS BUT DOES NOT RUN
Refer to the appropriate diagnostic procedure below for the vehicle being
serviced.
- Engine Cranks But Does Not Run - 1.2L (L2Q LDC LWD) or 1.4L (L2I L2N L2Z
LDD LUH LUJ
LUV) engine
INSPECTION/MAINTENANCE SYSTEM CHECK
Refer to the appropriate diagnostic procedure below for the vehicle being
serviced.
- Inspection/Maintenance System Check - 1.2L (L2Q LDC LWD) or 1.4L (L2I
L2N L2Z LDD LUH
LUJ LUV) engine
DIAGNOSTIC REPAIR VERIFICATION
NOTE: After a repair has been made, some DTCs require the ignition
to be turned OFF
then back ON before the scan tool function will clear the DTC.
- Ignition OFF.
- Install any components or connectors that have been removed or replaced
during diagnosis.
- Perform any adjustment, programming or setup procedures that are
required when a component or
module is removed or replaced.
- Ignition ON.
- Clear the DTCs.
- Turn the ignition OFF for 60 seconds.
- If the repair was related to a DTC, duplicate the Conditions for Running
the DTC and use the Freeze
Frame/Failure Records, if applicable, in order to verify the DTC does not
set. If the DTC sets or another
DTC is present, refer to the Diagnostic Trouble Code (DTC) List - Vehicle
and perform the appropriate
diagnostic procedure.
Or
If the repair was symptom related, duplicate the conditions under which the
customer concern occurred to
verify the repair. If the customer concern reoccurs or another symptom is
present, return to Symptoms -
Vehicle and perform the appropriate symptom diagnostic.
READ NEXT:
BODY CONTROL MODULE SCAN TOOL INFORMATION
Body Control Module Scan Tool Data Parameters
Body Control Module Scan Tool Output Controls
CHASSIS CONTROL MO
Telematics Communication Interface Control Module Scan Tool Data
Parameters
Telematics Communication Interface Control Module Scan Tool Output
Controls
SEAT MEMORY CONTROL MODULE SCAN TOOL INF
The power steering control module scan tool data parameters list contains all
power steering related parameters
that are available on the scan tool. The list is arranged in alphabetical order.
A giv
SEE MORE:
Trim Height Measurement
Trim height is a predetermined measurement relating to vehicle ride height.
Incorrect trim heights can cause the
vehicle to bottom out over bumps, damage to the suspension components and
symptoms similar to wheel
alignment problems. Check the trim heights when diagnosing su
Fig. 8: Rear Object Alarm Control Module
Rear Object Alarm Control Module Replacement
FRONT OBJECT ALARM SENSOR HOUSING REPLACEMENT
Remove the front fascia. Refer to Front Bumper Fascia Replacement (Trax)
, Front Bumper Fascia
Replacement (Encore) .
Fig. 9: Identifying Rear Object Sens