Chevrolet Trax: Rear Window Wiper/ Washer
The rear wiper/washer controls are on the end of the windshield wiper lever.
.gif)
ON: Press the upper portion of the button for continuous rear window wipes.
OFF: The rear wiper turns off when the button is returned to the middle position.
INT (Intermittent Rear Wipes): Press the lower portion of the button to set a delay between wipes.
.gif)
REAR (Rear Washer): Push
the windshield wiper lever forward
to spray washer fluid on the rear
window. The lever returns to its
starting position when released.
Reverse Gear Wipes
If the rear wiper control is off, the rear wiper will automatically operate continuously when the shift lever is in R (Reverse), and the front windshield wiper is performing low or high speed wipes. If the rear wiper control is off, the shift lever is in R (Reverse), and the front windshield wiper is performing interval wipes, then the rear wiper automatically performs interval wipes.
This feature can be changed. See Vehicle Personalization
The windshield washer reservoir is used for the windshield and the rear window. Check the fluid level in the reservoir if either washer is not working. See Washer Fluid
READ NEXT:
Compass
The vehicle may have a compass
display in the Driver Information
Center (DIC).
Setting the Compass Zone
Under certain circumstances, such
as during a long trip or moving to a
new area, the compass zon
Clock
Radio without Touchscreen
The infotainment system controls
are used to access the time and
date settings through the menu
system. See Operation
for information about how to use the
menu system.
Setti
Power Outlets
The accessory power outlets can be
used to plug in electrical equipment,
such as a cell phone or MP3 player.
The vehicle has an accessory
power outlet in front of the
cupholders on the center stack.
SEE MORE:
Drive Range, Fourth Gear - Gen 2/Hybrid
Fig. 13: Drive Range, Fourth Gear -- Gen 2/Hybrid Fluid Flow Diagram
Drive Range - Fourth Gear Default (Gen 2/Hybrid)
If the transmission encounters an electrical component malfunction, the
transmission will default to Fourth gear.
All solenoids will default to their normal state. If the torque
DTC B0014, B0021, B0031, OR B0038: Seat side air bag deployment loop
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
DTC Descriptors
D
