Chevrolet Trax Owners & Service Manuals

Chevrolet Trax: If a Tire Goes Flat

It is unusual for a tire to blow out while driving, especially if the tires are maintained properly. See Tires

If air goes out of a tire, it is much more likely to leak out slowly. But if there ever is a blowout, here are a few tips about what to expect and what to do: If a front tire fails, the flat tire creates a drag that pulls the vehicle toward that side. Take your foot off the accelerator pedal and grip the steering wheel firmly. Steer to maintain lane position, and then gently brake to a stop, well off the road, if possible.

A rear blowout, particularly on a curve, acts much like a skid and may require the same correction as used in a skid. Stop pressing the accelerator pedal and steer to straighten the vehicle. It may be very bumpy and noisy. Gently brake to a stop, well off the road, if possible.

Warning

Driving on a flat tire will cause permanent damage to the tire.

Re-inflating a tire after it has been driven on while severely underinflated or flat may cause a blowout and a serious crash.

Never attempt to re-inflate a tire that has been driven on while severely underinflated or flat.

Have your dealer or an authorized tire service center repair or replace the flat tire as soon as possible.

Warning

Lifting a vehicle and getting under it to do maintenance or repairs is dangerous without the appropriate safety equipment and training. If a jack is provided with the vehicle, it is designed only for changing a flat tire. If it is used for anything else, you or others could be badly injured or killed if the vehicle slips off the jack. If a jack is provided with the vehicle, only use it for changing a flat tire.

If a tire goes flat, avoid further tire and wheel damage by driving slowly to a level place, well off the road, if possible. Turn on the hazard warning flashers. See Hazard Warning Flashers

Warning

Changing a tire can be dangerous. The vehicle can slip off the jack and roll over or fall causing injury or death. Find a level place to change the tire. To help prevent the vehicle from moving:

  1. Set the parking brake firmly.
  2. Put an automatic transmission in P (Park) or a manual transmission in 1 (First) or R (Reverse).
  3.  Turn off the engine and do not restart while the vehicle is raised.
  4. Do not allow passengers to remain in the vehicle.
  5. Place wheel blocks, if equipped, on both sides of the tire at the opposite corner of the tire being changed.

When the vehicle has a flat tire (2), use the following example as a guide to assist in the placement of the wheel blocks (1), if equipped.

If a Tire Goes Flat

  1. Wheel Block (If Equipped)
  2. Flat Tire

The following information explains how to repair or change a tire.

    READ NEXT:

     Tire Changing

     Removing the Spare Tire and Tools

    The spare tire and tools are located in the storage compartment in the rear of the vehicle. Without Subwoofer Wrench Jack Strap With Subwoofer To access the spare tire and tools: Open the l

     Removing the Flat Tire and Installing the Spare Tire

    Do a safety check before proceeding. See If a Tire Goes Flat Remove the wheel cover, if the vehicle has one, to reach the wheel bolts. Turn the wheel wrench counterclockwise to loosen

    SEE MORE:

     Steering linkage inner tie rod inspection

    Special Tools GE-8001 Dial Indicator Set For equivalent regional tools, refer to Special Tools. NOTE: This inspection procedure does not supersede local government required inspections that have more stringent requirements. Turn the ignition key to the ON position with the engine OFF. Fig. 4:

     DTC B101D: Electronic control unit hardware

    Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Review Strategy Based Diagnosis for an overview of the diagnostic approach. Diagnostic Procedure Instructions provides an overview of each diagnostic category. DTC Descriptor DT

    © 2019-2024 Copyright www.chevtrax.com