Chevrolet Trax: Door Locks
To lock or unlock a door manually:
- From the inside, to lock the door, use the lock knob on the top of the door panel.
- From the outside, turn the key
toward the front or rear of the
vehicle, or press
.gif)
or
.gif)
on the
Remote Keyless Entry (RKE)
transmitter.
Power Door Locks
.gif)
.gif)
: Press to unlock the doors.
.gif)
: Press to lock the doors.
See Power Door Locks
Liftgate
.gif)
To open the liftgate, press .gif)
on
the
door lock switch or on the Remote
Keyless Entry (RKE) transmitter to
unlock all doors, then use the touch
pad on the trunk.
Press .gif)
on the door lock switch or
on the RKE transmitter to lock the
liftgate.
See Remote Keyless Entry (RKE) System Operation
See Liftgate
Windows
.gif)
Press the switch to lower the window. Pull up on the front edge of the switch to raise it. See Power Windows
The switches work when the vehicle is in ON/RUN or ACC/ ACCESSORY, or when Retained Accessory Power (RAP) is active.
See Retained Accessory Power (RAP)
READ NEXT:
Seat Adjustment
Manual Seats
To adjust a manual seat:
Pull the handle at the front of
the seat.
Slide the seat to the desired
position and release the handle.
Try to move the seat back and
forth to be sure i
Heated Seats
If available, the controls are on the
climate control panel. To operate,
the engine must be running.
Press or
to heat the driver or
passenger seat.
See Heated Front Seats
Head Restraint Adjustme
Mirror Adjustment
Exterior Mirrors
To adjust the mirrors:
Turn the selector switch to L
(Left) or R (Right) to choose the
driver or passenger mirror.
Move the control to adjust the
mirror.
Turn the selec
SEE MORE:
Safety Locks
The rear door safety locks prevent
passengers from opening the rear
doors from inside the vehicle.
Manual Safety Locks
If equipped, the safety lock is
located on the inside edge of the
rear doors. To use the safety lock:
Insert the key into the safety lock
slot and turn it so the slot is in
th
Front side door lock cylinder coding (free wheeling)
Special Tools
BO-49753 Assembly Tool
Fig. 9: Identifying Lock Components
The door lock cylinder uses 8 of the 8 cut positions. The tumbler positions
are staggered from side to side, 4 on one side and 4 on the other, are not
self-retaining, and are not snap in.
NOTE: All lock cylinders for side m
© 2019-2024 Copyright www.chevtrax.com
