Chevrolet Trax: Where Are the Airbags? (Mexico)
.gif)
The driver frontal airbag is in the center of the steering wheel.
The front outboard passenger frontal airbag is in the passenger side instrument panel.
.gif)
Driver Side Shown, Passenger Side Similar
If the vehicle has seat-mounted side impact airbags for the driver and front outboard passenger, they are in the side of the seatbacks closest to the door.
If the vehicle has roof-rail airbags for the driver, front outboard passenger, and second row outboard passengers, they are in the ceiling above the side windows.
Warning
If something is between an occupant and an airbag, the airbag might not inflate properly or it might force the object into that person causing severe injury or even death. The path of an inflating airbag must be kept clear. Do not put anything between an occupant and an airbag, and do not attach or put anything on the steering wheel hub or on or near any other airbag covering.
Do not use seat accessories that block the inflation path of a seat-mounted side impact airbag.
Never secure anything to the roof of a vehicle with roof-rail airbags by routing a rope or tie‐down through any door or window opening. If you do, the path of an inflating roof-rail airbag will be blocked.
READ NEXT:
When Should an Airbag Inflate? (U.S. and Canada)
This vehicle is equipped with
airbags. See Airbag System
(Mexico) or Airbag
System (U.S. and Canada) . Airbags are designed to
inflate if the impact exceeds the
specific airbag system's deployme
When Should an Airbag Inflate? (Mexico)
This vehicle is equipped with
airbags. See Airbag System
(Mexico) or Airbag
System (U.S. and Canada). Airbags are designed to
inflate if the impact exceeds the
specific airbag system's deployment
thre
What Makes an Airbag Inflate?
In a deployment event, the sensing
system sends an electrical signal
triggering a release of gas from the
inflator. Gas from the inflator fills the
airbag causing the bag to break out
of the cover. Th
SEE MORE:
Evaporative emission control system diagnosis
Special Tools
EN 41413-VLV EVAP Service Port Vent Fitting
Operating Instructions for the Evaporative Emission System Tester (EEST)
Vehicle Setup
WARNING: Refer to Fuel and Evaporative Emission Pipe Warning .
CAUTION: Refer to Clean, Dry, Low Pressure Gas Source Caution
NOTE: When servicing the EVAP
Camshaft timing chain installation
Special Tools
EN-952 Fixing Pin
EN-953-A Fixing Tool
EN-955-10 Fixing Pin from EN-955 Kit
For equivalent regional tools, refer to Special Tools.
The engine should be adjusted to TDC.
The crankshaft should be locked with EN-952 fixing pin.
The camshaft should be locked with EN-953-A fixing t
