Chevrolet Trax: Roof
Sunroof
If equipped, the sunroof only operates when the ignition is turned to ON/RUN or Retained Accessory Power (RAP) is active.
Open/Close: Press and hold the front or rear of switch (1) to open or close the sunroof.
Vent: Press and hold the front or rear of switch (2) to vent or close the sunroof.
Manually close the sunshade.
The sunroof will not operate if the vehicle has an electrical failure.
Dirt and debris may collect on the sunroof seal or in the track. This could cause an issue with sunroof operation or noise. It could also plug the water drainage system.
Periodically open the sunroof and remove any obstacles or loose debris. Wipe the sunroof seal and roof sealing area using a clean cloth, mild soap, and water. Do not remove grease from the sunroof.
If water is seen dripping into the water drainage system, this is normal.
READ NEXT:
Front Seats
Warning
With head restraints that are not
installed and adjusted properly,
there is a greater chance that
occupants will suffer a neck/
spinal injury in a crash. Do not
drive until the head restraints
SEE MORE:
Brake pressure modulator valve front brake pipe replacement
(LEFT)
Removal Procedure
WARNING: Refer to Brake Dust Warning .
WARNING: Refer to Brake Fluid Irritant Warning .
CAUTION: Refer to Brake Fluid Effects on Paint and Electrical
Components Caution
Remove the battery. Refer to Battery Replacement .
Fig. 75: Brake Pressure Modulator Valve (BPMV) Front Bra
DTC B101E: Electronic control unit software
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
DTC Descriptor
DT
